Hello and welcome!

On 1 July 2021 there will be an EU regulation on what VAT you have to pay when buying online.

In order for you to see the correct VAT, we have automatically retrieved information about which country you are in. Please change it if it was wrong. This information is only used to show the correct VAT on the products.

The correct VAT will automatically be shown at the checkout regardless of the country you choose here.

We have used your IP number ( for this check.


  • Marking/Mortise Gauge Heads

Though designed for use with our Veritas Wheel Marking Gauges, these gauge heads are a simple retrofit for any marking gauge with a 5/16" diameter shaft. 

Made from carbon steel, the 5/8" diameter wheel cutters will scribe at any point in their circumference and slice rather than tear fibers for clean, accurate cuts. The single-bevel cutters are usable in-line for marking parallel lines, or with bevels facing for sure mortise sizing and chisel registration. Secured with integral set screws, the blades can be set as close as 3/8" apart. The included shaft collar registers against the marking gauge fence to ensure the shaft remains parallel to the workpiece, preventing accidental tilting of the cutters in use; this is especially useful when scribing large offsets from the fence. 

Supplied as a pair of cutters with a shaft collar, hex key and instructions. 

Write a review

Note: HTML is not translated!
    Bad           Good

Marking/Mortise Gauge Heads

  • Brand: Veritas tools
  • Product Code: 15N01.01
  • Availability: In Stock
  • 145.00kr (SEK)

  • Ex Tax: 116.00kr (SEK)

Tags: Marking/Mortise Gauge Heads, 15N01.01, Marking Gauge