Hello and welcome!

On 1 July 2021 there will be an EU regulation on what VAT you have to pay when buying online.

In order for you to see the correct VAT, we have automatically retrieved information about which country you are in. Please change it if it was wrong. This information is only used to show the correct VAT on the products.

The correct VAT will automatically be shown at the checkout regardless of the country you choose here.

We have used your IP number (3.236.117.38) for this check.

Country:


Stainless-Steel Drawbore Pin for 1/4" pegs

Drawboring is a joinery technique that produces strong, durable joints without need for glue or clamps. The key to making a tight joint this way is to offset the peg holes by 1/16" to 3/32" between the mortise and tenon, so as a wooden peg is inserted, the joint is drawn together. Ensuring proper alignment before final assembly can be tricky. This is where a drawbore pin is useful. Its tapered shaft acts as a wedge, drawing the joint together just as a wooden peg would, allowing a test fit prior to assembly. It also partially aligns the offset holes, helping clear the way for the wooden peg that will ultimately secure the joint.

The pins are available in two sizes for working with common peg diameters. For use with 1/4" diameter pegs, the 10-1/2" long overall pin has a 6-3/8" shaft that tapers to a point from a 5/16" diameter base. The 12" long overall pin with a 7-7/8" shaft is for use with 3/8" diameter pegs and tapers to a point from a 7/16" diameter base. Both turned stainless-steel shafts run the length of the tool. The octagonal bubinga handles are epoxied in place for strength.


 

Write a review

Note: HTML is not translated!
    Bad           Good

Stainless-Steel Drawbore Pin for 1/4" pegs

  • Brand: Veritas tools
  • Product Code: 15K01.01
  • Availability: In Stock
  • 277.50kr (SEK)

  • Ex Tax: 222.00kr (SEK)

Tags: Stainless-Steel Drawbore Pin for 1/4" pegs, 15K01.01, Drawboring tools