Tormek Knife Sharpening, Jig SVM-140
The Tormek original grinding jig SVM-140 has been developed especially for long and flexible knives, e.g. filleting knives. Its larger width, 140 mm (5½"), stabilizes a long and thin blade and the jig copes with blades longer than 160 mm (6¼").
A Durable Edge
Compared to grinding methods where you quickly pull the knife through a knife sharpener or sharpen it by using a honing stone, the Tormek knife jigs restore the blade to its original and optimal edge angle. So you do not just sharpen or hone at the very tip of the edge, as you do with honing stones or with a sharpening steel, which causes the edge angle to increase unintentionally. After a few sharpenings by hand, the edge sooner or later will need to be restored to the correct edge angle.
A sharp edge.
The edge is worn and blunt.
After honing on a bench stone the edge is sharp again, but with an increased edge angle.
After another period of use the edge is blunt again.
Another honing sharpens the edge to a still larger angle.
The edge is now re-ground with Tormek to its original shape.
Kind to the steel
Since the edge is continuously cooled with water, there is no risk that the steel will become overheated and lose its hardness. You remove the minimum amount of steel so your valuable knives will last for a long time.
The jig rests on the Universal Support and gives you full control over the edge angle. The burr that develops during sharpening is easily removed on the Tormek Leather Honing Wheel where it is polished to a razor edge. You get a superior sharpness that will last longer.
Edge angles for different usage
You can set a suitable edge angle by using the Tormek AngleMaster that comes with the machine. A knife for cutting meat should have a larger edge angle then a knife for cutting vegetables. A small edge angle (25°) will cut easily but it will also be more sensitive to wear and damage. A larger edge angle (40°) will give a stronger and more durable edge.
This jig is made especially for long and thin knives. It works in the same way as the SVM-45 jig but it is wider and therefore gives more support to long and thin blades.
The jig comprises an adjustable clamp (1) for holding knives of any thickness and an adjustable stop (2). You adjust the jig to the knife thickness with the screw (3). You lock the tool by tightening the knob (4).
The jig rests on the Universal Support. The exact edge angle is set by rotating the stop or with the Micro Adjust on the Universal Support. The Universal Support is placed vertically for grinding towards the edge.
SVM-140 Knife Jig
- Brand: Tormek
- Product Code: SVM-140
- Availability: Out of stock
- Ex Tax: 303.73kr (SEK)